A Bore cycle is used to form shapes inside a hole. The following boring cycles are available:

Drag  
The tool is fed to the specified depth at the controlled feed rate. Then the spindle is stopped and the tool retracts rapidly.

No Drag  
The tool is fed to the specified depth at the controlled feed rate. It is then stopped to orient the spindle, moved away from the side of the hole and then retracted.

Manual  
The tool traverses to the programmed point and is fed to the specified depth at the controlled feed rate. Then the tool stops and is retracted manually.

User Defined Bore1 / User Defined Bore2
These are user defined Bore types.