PPG Editor: Variables

<< Click to Display Table of Contents >>

Navigation:  Post Editor > Use Legacy Post > PPG Editor >

PPG Editor: Variables

This tab lists all the variables used in the macros in the RhinoCAM Post Processor.

 

tog_minusPPG Editor: Variables
PPG Editor: Variables

PPG Editor: Variables
tog_minusVariables

The variables that can be used are listed in the table below.

The variables that start with “CYCL_” are used only for the cycles commands.

table17
tog_minusVariables

The variables that can be used are listed in the table below.

The variables that start with “CYCL_” are used only for the cycles commands.

table18
tog_minusRelated Topics

Other PPG Editor Sections:

General

Start/End

Tool Change

Setup

Spindle

Feed Rate

Motion

Circle

Helical/Spiral Cycles

Multi Axis Motion

Cutter Compensation

Cut Motion Start/End

Cycles

Miscellaneous