Use Optimizations

Check this box to enable the feedrate reduction parameters in the Toolpath Optimization tab of the toolpath operation dialog.

Limiting Corner Angle  

Toolpaths equal to or below this Angle will be subject to these Feedrate Optimization rules.

Distance before corner to start reduction  

This is the linear Distance BEFORE a corner when Feedrate Optimization begins.

Distance after corner to reset feedrate  

This is the linear Distance AFTER a corner when Feedrate Optimization ends.

Minimum distance between feedrate changes  

This is the Minimum Distance between within which Feedrate Optimization will occur.  Adjust this value to the minimum distance between corners on your part.

Feedrate reduction percentage  

This is the percentage of the default feedrate to apply for Feedrate Optimization.  For example, entering 0.25 will apply a 25% reduction in feedrate at the corner angles specified.  This value must be less than 1 to apply the correct feedrate reduction.

Motions to ignore if shorter than  

Individual toolpath motions shorter than this distance will be ignored for Feedrate Optimization.

Motion strings to ignore if shorter than  

Accumulative (i.e., consecutive) toolpath motions shorter than this distance will be ignored for Feedrate Optimization.